4Way Super Loom for 60 Series Landcruiser – By JTX Lighting
4Way Super Loom for 60 Series Landcruiser – By JTX Lighting
4Way Super Loom for 60 Series Landcruiser – By JTX Lighting
4Way Super Loom for 60 Series Landcruiser – By JTX Lighting
4Way Super Loom for 60 Series Landcruiser – By JTX Lighting
4Way Super Loom for 60 Series Landcruiser – By JTX Lighting
4Way Super Loom for 60 Series Landcruiser – By JTX Lighting
4Way Super Loom for 60 Series Landcruiser – By JTX Lighting
JTX Lighting

4Way Super Loom for 60 Series Landcruiser – By JTX Lighting

$155.00 AUD Save $-155.00 AUD
0 in stock

This wiring kit it is used to make up to 4x LED Headlights and globes compatible in Toyotas and Suzukis, and any other vehicle with earth switching/reverse polarity.

This is a 4 banger loom – it will do 4 x headlights. If you only have 2 x lights we aso list same loom but for 2 x lights.

This loom will fix all of the following:

  • Negative or Earth switching (which all toyotas have).
  • Reverse polarity issues.
  • Blue hi-beam dash light.
  • Spotties not coming on in high beam.
  • Some cars have computers polling to test loads and these satisfy those computers too.
  • Brighten globes by providing heavy duty fat power cable and earth wiring to globes so you can run hi wattage globes up to 150w . Even standard globes will run a lot brighter.

So this does everything and that’s why we call it the super loom.

No matter what brand of LED you are trying to use, if you have a Toyota or a Suzuki then you need to sort out your wiring.

The installation process is dead easy and takes just 5 minutes.
  • It has one plug that goes into one of your old headlight sockets. That’s how the controller in the harness receives the message that the lights are on and in high or low beams.
  • The loom presents you with 4 new headlight sockets, one for each light.
  • The loom has wire with a 50 Amp massive maxi fuse going to +ve on the battery. You wont need any larger fuse for LED.
  • The loom has an earth wire that can go to an earth on the body or to -ve on the battery.

It’s the ultimate headlight problem solver.

If you have a 60 series Landcruiser with rectangular lights you will also need our JTX Load modules as those need a heavier load to make high beam turn off when you dip to low beam. And in that case the load modules have to plug into the factory sockets and the harness will plug into one of those in the outer light position. Here is the link to the JTX Load Modules.

For more information, please refer to our Terms of Service. By purchasing off our site you acknowledge that you have read and agree to our Terms of Service. 

Back to HJ60