Smart CANBUS Module (pair) for 60 Series Landcruiser – By JTX Lighting
These newSMARTmodules by JTX now do the job of their old loom which addressed negative switching and they also fix the blue hi beam dash lights and spotties – all in one (or 2 I should say).
To eliminate confusion and for all those who can’t read instructions we set out to make these as fool proof as possible. Simply plug these into the headlight sockets and then plug your new LED lights into these. And that’s all there is to it. No loom and no auto elecs needed.
These now fix all of the following …
Negative or Earth switching which all toyotas have
Reverse polarity issues
Blue hi beam dash light
Spotties not coming on in high beam
Some cars have computers polling to test loads and these satisfy those computers too.
No matter what brand of LED or even HID you are trying to use, if you have a Toyota or a Suzuki then you do need these and these are all you need.
You need 1 module per light. This listing is for 2 modules. If you have 4 lights you will need a second set.
LED wiring Kit for 60 Series Landcruiser – By JTX Lighting
This wiring kit it is used to make LED Headlights and globes compatible in Toyotas and Suzukis, and any other vehicle with earth switching/reverse polarity.
This wiring kit solves problems faced by Toyotas and Suzukis running LED Headlights and globes. It is no longer mandatory as our JTX CANBUS Modules now also function the same. Customers may still wish to purchase this if they want their inner headlights on their landcruiser to function as low-beam and high-beam.
Reverse polarity – a conventional globe will work no matter what direction the current passes through it. LED stands for Light Emitting Diode and the role of a Diode is to only allow power to pass through it in one direction only. And you guessed right – virtually every Toyota and Suzuki want the power to go through in the wrong direction. Virtually every other type of car is OK. This loom has the smarts to identify when the lights are on and send power to the globe in the conventional LED direction.
Earth switching – some vehicles (and again mainly Toyota) have constant power to both sides of the globe and because there is no voltage difference the light is off. And when you turn them on one side of the globe becomes earthed and then the light works. This loom runs new wires to the lights and they behave normally when the controller in the loom senses the lights are on.
The installation process is dead easy and takes just 5 minutes.
It has one plug that goes into one of your old headlight sockets. That’s how the controller in the harness receives the message that the lights are on and in hi or low beams.
The loom presents you with 2 new headlight sockets, one for each light.
The loom has wire with a 20 Amp fuse going to +ve on the battery. You wont need any larger fuse for LED.
The loom has an earth wire that can go to an earth on the body or to -ve on the battery.